I have the original Ruger.com 10/22 with the plastic stock. I was to add a sling studs so that I can do another Apple seed. How can I add the rear sling stud if the stock is hollow?
-
Ben -
I saw an article recently where a guy took,off the butt plate and drilled a small hole and filled the end of the stock with epoxy. Drilled and tapped the stud in like normal after that.Pat ------> NRA Lifetime Endowment Member #FAAFO -
Had campsite do the studs on my wife's takedown.....I tend to strip and break everything. Believe they just screwed it in....its held up so far but if it does back out, I'd try the epoxy route.The escape is nowhere near complete. The inventor of LIBERAL fishing. (soon to be seen on ESPN 45 because the 44th never worked.)Comment
-
+1 campsite, screw DSIComment
-
Drill a hole that's half the diameter of the screw, screw in the stud and be done with it. If you manage to pull the stud out of the plastic you're doing something stupid.
I did the same thing for a 10/22 Tupperware stock and have shot in LIPSA matches with the sling set tight. No problem.SHADAP VARMINT!Comment
Comment